|
ИСТИНА |
Войти в систему Регистрация |
ИПМех РАН |
||
Primary and secondary distributions after a small-amplitude potential step at disk electrode coated with conducting filmстатья
Статья опубликована в высокорейтинговом журнале
Информация о цитировании статьи получена из
Web of Science,
Scopus
Статья опубликована в журнале из списка Web of Science и/или Scopus
Дата последнего поиска статьи во внешних источниках: 18 июля 2013 г.
- Авторы: Vorotyntsev Mikhail A., Konev Dmitry V.
- Журнал: Electrochimica Acta
- Том: 56
- Номер: 25
- Год издания: 2011
- Издательство: Elsevier BV
- Местоположение издательства: Netherlands
- Первая страница: 9105
- Последняя страница: 9112
- DOI: 10.1016/j.electacta.2011.07.004
- Аннотация: The set of equations and boundary conditions for the "primary potential/current distribution" after a small-amplitude potential step has been analyzed for a film-coated disk electrode in contact with an electrolyte. The solution of these equations provides the overall short-time resistance of this system, R(tot), which is determined by the short-time resistance of the electrolyte solution in contact with the bare disk electrode, R(s), and the short-time film resistance to the current passage in the normal direction, R(f) = L(f)/kappa(f) pi r(o)(2)(r(o), disk radius; L(f), film thickness; kappa(f), its specific conductivity). The deviation of R(tot) from the sum of these resistances, R(s) + R(f), originates from a three-dimensional potential/current distribution in solution. Procedures to calculate the film resistance and its specific conductivity on the basis of the measured values of R(tot) and R(s) have been proposed. Similar analysis has also been carried out for the "secondary potential/current distribution" in the same system. The overall resistance for this regime is related to the short-time solution resistance, R(s), and to the total resistance of the electrode, equal to the sum of the resistance, R(f), and two interfacial resistances, R(m/f) and R(f/s). A method to determine the bulk-film parameters, R(f) and kappa(f), from data for the secondary distribution is discussed. Advantages and restrictions of the proposed route to transport parameters of a film at the electrode surface are analyzed, in comparison with existing methods of their determination. (C) 2011 Elsevier Ltd. All rights reserved.
- Добавил в систему: Воротынцев Михаил Алексеевич