Evaluation of the Role of the Activating Application Method in the Cold Sintering Process of ZnO Ceramics Using Ammonium Chloride

Smirnov, A.V.; Kornyushin, M.V.; Kholodkova, A.A.; Melnikov, S.A.; Stepanov, A.D.; Fesik, E.V.; Mnatsakanyan, V.V.; Smirnov, A.; Ivakin, Y.D.

Авторы: Smirnov Andrey V., Kornyushin Maxim V., Kholodkova Anastasia A., Melnikov Sergey A., Stepanov Artem D., Fesik Elena V., Mnatsakanyan Vilen V., Smirnov Anton, Ivakin Yurii D.
Журнал: Materials
Том: 16
Номер: 1
Год издания: 2023
Издательство: MDPI
Местоположение издательства: Basel, Switzerland
Номер статьи: 408
DOI: 10.3390/ma16010408
Аннотация: The influence of the method of applying the activating additive ammonium chloride and its concentration on the density and microstructure of zinc oxide ceramic obtained by cold sintering at 244 °C was investigated. The activating agent was applied by two methods: impregnation and subsequent autoclave treatment. When the powder was activated by the impregnation method, the crystal sizes remained at the initial level of 0.17–0.19 μm. After the autoclave treatment, the crystal sizes increased to 0.31–0.53 μm. Samples of cold sintering ZnO with relative density up to 0.96 and average grain sizes 0.29–0.86 μm were obtained. ZnO powders and ceramic samples were analyzed using SEM, TGA/DSC, and XRD to reveal the effect of the powder activation method and cold sintering conditions on the material microstructure. The effect of ammonium chloride concentration on grain growth and microstructure of ceramic samples is shown. It was found that the average grain size of ceramic samples with an increase in additive concentration passes through a minimum. In cold sintering of the autoclave activated powder, the effect of reducing the average grain size was observed. The results of this work are discussed on the basis of the idea of the solid-phase mobility of the crystal structure arising when interacting with an aqueous medium.
Добавил в систему: Холодкова Анастасия Андреевна

	ИСТИНА	Войти в систему Регистрация
	ИПМех РАН
	Главная Поиск Статистика О проекте Помощь

ИСТИНА

ИПМех РАН

Evaluation of the Role of the Activating Application Method in the Cold Sintering Process of ZnO Ceramics Using Ammonium Chlorideстатья Исследовательская статья

Прикрепленные файлы